There are probably lots of ways to do stepping stones. I have my way and it works for me. There are lots of things you can put on stepping stones for your garden, like dishes, stones, marbles, keys, whatever you think will look good in a stepping stone. This type of mosaic is actually called Pique Assiette, which roughly translates to “stolen dishes”. The beauty of doing a stepping stone is that the same method works for most outside mosaic projects. Check out more of our garden stepping stones.
I’m not a big fan of really orderly designs, with symmetrical elements or tidy circles of pieces arranged in a regimented way. No, I tend to go for the intuitive and fast method of working.
First of all, although I’ve seen lots of sites that say otherwise, this is not suitable for children. It has sharp shards from dishes, it has caustic cement and requires some strength and lots of common sense. I am cutting myself all the time and keep bandages handy and I’m way past childhood.
Secondly, I’d like to say, if you are going to make these, use the proper precautions with mortar and grout. These are caustic materials, they require that you use dust masks when mixing to avoid breathing in the caustic dust. They require that you use rubber gloves to avoid getting the caustic mortar on your skin. That said, read the package, note the cautions. Please don’t go leaving this stuff around children and pets! Please remember to clean up as soon as you are done and make sure not to leave this stuff in bowls to harden into cement that you will never ever get off.
You may wonder why I have a photo of a pail of water? Well, the next precaution is NEVER NEVER rinse off anything with cement on it down a drain. It will set and your drains will be plugged! Ok, so why the pail? That’s where I do all my rinsing of gloves, mixing bowls and implements. I let the cement settle for a day or so and then gently pour off the water into a garden path and scrape the cement that settled into the bottom of the pail into a bag and put it in the garbage. There won’t be much but, hey, better in the bag than in your drain. Both mortar and grout have cement in them.
An important note about dishes and tile to use. If you use tile that is meant for indoor use or dishes that are porous under the glaze you will have this nasty thing happen.
The moisture will seep under the glaze and when it’s cold the water will expand and pop the glaze right off the dish or tile. I know, because it’s happened to us. So make sure the dish is really dense and not porous and use tile that is very dense and meant for outside use.
The last important note. Wear goggles when snipping dishes. Broken pieces have a way of flying out and hitting someone. Be careful, for obvious reasons with shards. Don’t wipe away little shards with your bare hands, use a dust brush.
OK enough warnings. On to the fun stuff. As I said, I like the intuitive way of creating stepping stones. But having said that I don’t judge what others may like. Creativity is self-expression after all.
You will need:
A concrete stepping stone
Dishes and/or tile
a work table
a pail of water
old cotton socks
Gray or White Mortar or thin set ( I use it in powder form and add water)
a jar of clean water
a bowl for mixing mortar and grout in ( I use old stainless steel mixing bowls)
a trowel for applying the mortar
something to scrape between the pieces to remove too much mortar, like an old knife.
two-wheeled glass cutter or tile nippers
sanded grout ( it comes in colors, so have fun)
Step 1- Getting ready to start
I buy concrete stepping stones from the local home building supply store. We used to make our own, but honestly, it wasn’t worth the effort. Stones are about $2 or $3 to buy. They come round or square.
Put a concrete stepping stone on a work table so you don’t have to be bent over the whole time while creating it. You’ll thank me later. I like to cover the work table with plastic first to save it for other uses. Also, it’s a good idea to put the cement stepping stone up on a few little blocks of wood to raise it off the table surface. It’ll make it easier to get your fingers under when you finally pick it up to move it.
Step 2- Cut up the dishes and tiles
Please put on your eye protection! I wear glasses anyway so that’s mine but really protective goggles are worth it.
Cut up the dishes into bits and pieces using nippers or two-wheel cutters or tile cutters. For cutting up tile, use the scoring wheel on the tile cutters to score the tile and then break it with the tile cutters. If you don’t know how to use one ask the clerk in the tile store, they’ll usually be happy to demonstrate.
Play around a bit with the arrangement. You could arrange them all before hand on an area approximately the same size as the stepping stone. More about this later.
Since mortar sets in about 20 minutes max, laying out your pieces on another surface will cut down on the time it takes. Or you could do it my way and just arrange them right on the mortar and wing it. Keeping in mind that the mortar loses its stickiness and you may have to make a little new mortar to finish sticking down pieces.
Step 3- Mixing the mortar
Put on your Dust mask! Put on your Rubber gloves! Seriously!
Wear your rubber gloves! I like to mix with my hands, encased in rubber gloves of course. Don’t do this bare handed! It’s caustic. see warnings above!
Put the powdered mortar in the mixing bowl. You will have to guess-timate here for the amount of mortar. Add water from the clean water in the jar, a tiny bit at a time. Mix up the mortar to a peanut butter consistency.
I like to use stainless steel mixing bowls that I find in thrift shops, they work well, and are reusable.
Get it to a peanut butter or just slightly thinner consistency by adding the water to the mortar ( this applies to grout also) very slowly as it will become too thin very quickly if you add too much.
Spread the mortar over the stone using a toothed trowel.
Lay each piece on the mortar and try not to squish up mortar between the pieces. You’ll need that space to put grout in later. If it happens, and it will, just remove it with a blade like tool. I cut and fit dishes as I need to as I go along.
You’ll have to move fast, mortar sets up on a hot day really fast, you’ll have only about 20 minutes! In fact I wasn’t fast enough on this one and it started to dry out and nothing stuck. So I scraped off the dry mortar and just buttered a bit on, for each section I had left to finish. Ok, it’s cheating a bit, but it did work.
BIG NOTE: watch out that when you put pieces down on the mortar that you don’t leave nasty points sticking up. You’ll know you did, painfully, later when you are smoothing grout over the pieces and snag your fingers on a point. And you wouldn’t want to step on a point later.
Be careful, this stuff is sticky and keep the top of your dish pieces clean and wiped off. Once mortar sets it’s cement and you won’t be able to remove it from the surfaces of the dishes!
NOTE FOR BIG PROJECTS: When we are doing a big project, or if we want to take our time designing a piece, we work a bit differently. We glue down each piece with a bit of mortar buttered on to the back of each piece. We just mix up tiny amounts of mortar at a time in a small bowl and apply it to each piece as we stick it down. When the mortar gets too hard, we just clean out the bowl and mix up another fresh tiny amount.
Step 4 -Take a break
Now that you have all the pieces mortared down, take a break and enjoy a cool iced tea. When you can’t move the pieces with your fingers, the mortar has set. We’d actually done the mortaring in the evening after a long day and stopped altogether to go in and watch movies. Of course, we cleaned up all the mortar mess like the bowls and implements first in the bucket of water! Then the next morning I was ready to grout.
Step 5 -Grouting
Put on your dust mask and rubber gloves!! Mix the grout in a bowl adding just a little bit of water from the jar at a time. Again I like to mix with my hands.
Get it to a peanut butter or just slightly thinner consistency.
Let the grout “slake” for a few minutes, no more than 5 and with your gloves on still from mixing it by hand pick up a handful and start “smushing ” it all over the surface.
Be sure to fill in each space between the pieces well. I use sanded grout always.
Step 6, or Why should I save old cotton socks?
I like to use old cotton socks to remove the grout from the surface. Some people like to use old sponges but I’ve found it’s just too easy to remove the grout from between the pieces with sponge. Dry old socks work well and you can turn them inside out and use the inside too. Once you have most of the grout removed from the surface leaving only a bit of hazy layer, let it sit. Break time again! Not too long, just 5 minutes and then back to work! Come back and with a clean sock shine up the pieces.
Step 6, Enjoy!
Enjoy the work you’ve just produced. Sit back and tell yourself what a genius you are! Then after your new wonderful stepping stone has had overnight to set and cure, dig it in to your chosen spot in the garden path. Hope you’ve enjoyed my tutorial. You can use this method for other outdoor projects like bird baths too. Check out our Mosaic bird baths too, if you’re interested. you can find them here: A Serendipitous Mosaic Bird bath and also A Beach Pottery Bird Bath. Bird baths are done a little differently. We create small batches of mortar and butter each piece as we go along. We set up under a pergola and make a summer project of it. They do take some time, so be patient and enjoy.
(BTW, if you’d like to make a comment, just click on the title. It’ll take you to comments….and we do appreciate comments )
50 thoughts on “How to Create a Pique Assiette Mosaic Stepping Stone – Helen’s Way”
Great tips, especially the safety tips! Thanks for sharing them! Your steps are so pretty!!
Hi Denise, Thank you!
This sounds genius! I can’t wait to try this! Thank you for all the great tips!
Thank you so very much for a wonderful tutorial. I am now off to the hardware store to buy supplies, YOU have given me the courage and knowledge that I needed to actually start a project…
Hi Vicky, Glad you found it all useful and hope you have fun making stepping stones.
Hi Maureen, Glad you found the tutorial helpful and inspiring. I’m sure you’ll have fun making stepping stones.
How do you seal it so that weather does not affect the grout nor the tile?
Hi Sam, Actually we never seal the grout on stepping stones and they seem to be ok. We made these way back in 2009. I do seal the grout on table tops with silicone sealer, only to keep the grout safe from stains from spills.
I am planning to mosaic a wooden post and would like to know do I need to do anything to the wood before putting thin set on it? Is there a difference in what type of grout I would use?
Thought I would reply to you by email as well as to the comment on my blog. I’m assuming that you’re planning a wooden post for outside, not inside. We do a lot of mosaic on plywood but it’s ONLY for interior mosaic. For outside, you have to take in consideration the weather, and the fact that water gets into wood and if it’s a cold climate, can freeze too. The water gets under the mosaic and will pop off your mosaic. I wouldn’t recommend doing a wooden post for outside. When I do mosaic on plywood I use a glue called mastic, which is a glue for doing bathroom tiles basically, but this is NOT for outside. The glue won’t stand up to the weather.
The problem of weather is always a stumbling block to doing exterior mosaic. This is why we’ve only done exterior mosaic on concrete stepping stones and used mortar to adhere the mosaic pieces. And then, as I said in my blog, you have to be careful to use mosaic pieces that are not porous and let water in under the glaze.
The stepping stones are done on cement or concrete blocks and the glue is thin set or mortar. Then the grout is exactly the same as interior grout, which is actually a cement. Hope this helps.
All the best,